A Gulf Coast winter is short, which is exactly why the heat fails on the first cold morning: the system has not run since March. Most Mobile homes heat with a heat pump, some with a gas furnace, and the two fail in different ways. Here is how to tell what is normal, what you can check, and when to call a licensed technician.
Call (251) 680-7500 Request a QuoteWalk outside. If the outdoor unit runs in winter, you have a heat pump, and most of what follows about cool air, defrost and emergency heat applies to you. If the outdoor unit sits idle and there is a gas line to the air handler or a flue through the roof, you have a gas furnace, and the problems are ignition, sensors and safeties. A few homes have electric heat strips alone; they behave like a very expensive toaster. What the symptoms mean, by the kind of heat:
Last winter, the homes we found without heat split between heat pumps (defrost boards, low refrigerant, failed disconnects) and gas furnaces (ignitors, thermocouples, flame sensors, gas lines), and nearly all of them had heat again within a day.
Sometimes it is neither the heat pump nor the furnace, but the electrical supply that feeds it. In January a Mobile home lost its heat. The heating equipment itself was fine; the 60-amp disconnect that feeds it had failed. Because our technicians are licensed for electrical work too, the same technician replaced it and had the heat back on that day, with no second contractor to wait for.
Call (251) 680-7500
Set the thermostat to heat, the fan to auto, and the set point a few degrees above the room. Replace the filter; a clogged filter trips a furnace's limit switch and starves a heat pump's indoor coil. Check that the thermostat is not on emergency heat. Check the breakers for the air handler and the outdoor unit, and the furnace's power switch, which looks like a light switch on or near the unit and gets turned off by accident. On a gas furnace, confirm the gas is on at the meter and at the valve by the unit.
One thing should never wait for a checklist: the smell of gas. In April, a Prichard homeowner smelled gas near the furnace. Our technician found a failed gas flex line at the furnace and replaced it the same day. In January, a Chickasaw furnace that would not light turned out to need a new thermocouple, and that was fixed the same day too.
If you smell gas, do not touch any switch. Leave the house, then call the gas company and 911 from outside. Everything else on this page can wait for a technician; that cannot.
Defrost board, sensors, reversing valve, outdoor fan and the low-voltage signals from the thermostat. The frozen-solid heat pump is usually one of these.
A heat pump low on refrigerant heats poorly and defrosts constantly. Charge, leak search and compressor draw are checked as they would be in July.
The electric backup is tested, and the thermostat's staging is corrected so the strips help on the coldest mornings instead of carrying the house all winter.
Ignitor, flame sensor, pressure switch, limit switch, gas valve and the control board's fault codes. Cleaned, adjusted or replaced, with the combustion checked afterward.
Heat exchanger inspection, flue and venting, carbon monoxide at the registers. A furnace that fails these is shut down and you are told exactly why.
Diagnosis first, then the written price, then the work. Heating season is short here; most repairs are same-visit from the truck.
Between the middle of December 2025 and the twentieth of March 2026 we ran ten no-heat calls, in Daphne, Grand Bay, Mobile, Prichard, Saraland and Theodore. Nine were seen the same day. Six of the ten came in two stretches of cold weather in January, two on the thirteenth and four between the twenty-seventh and the twenty-ninth, which is how a Gulf Coast heating season works: nothing for weeks, then everyone's first cold morning at once. What the tickets closed on:
January is also when the maintenance visits cluster: nine tune-ups on the seventh alone, the week after New Year's. That is the visit that finds the failing ignitor or the weak capacitor before the cold morning does.
Heat pumps have their own version of that first-cold-morning failure. A Daphne heat pump that stopped heating in January had a failed defrost control board, replaced the same day.
Same-day service on most weekdays across Mobile and Baldwin counties, and a current heating tune-up offer that catches these problems before the first cold front.
The heating side of the system is tested, the flame sensor cleaned, the defrost cycle run and the strips checked, in October instead of on the first thirty-degree morning. Ask about the current tune-up offer.
The cheapest insurance against a tripped limit switch or a frozen indoor coil.
Emergency heat runs the strips alone and triples the bill. It is for when the heat pump has failed, not for cold mornings.
A gas furnace that lights and shuts down a few seconds later is almost always a flame sensor coated with a thin layer of oxidation. The sensor cannot prove to the control board that there is a flame, so the board closes the gas valve for safety. Cleaning it is a ten-minute job on a tune-up, or a cold house in December. Ignitors crack, pressure switches stick when a flue is blocked by a wasp nest built over the summer, and limit switches trip when a filter has not been changed since the air conditioner was running.
Because the furnace runs so few hours a year here, these parts last a long time and then fail all at once on the first cold morning when everyone's heat comes on together. The fall tune-up is when we find them. Carrier, Trane, Lennox, Rheem, Goodman and the other major brands are all serviced.
"I've had a new HVAC unit installed with Mark and he was courteous, kind, friendly and always on time and had great communication. I have recommended them to all my neighbors."
— Scott J., Google review"I've worked with them on several projects and they are amazing to work with. Caleb has always been very responsive and keeps me informed of the status of each project. I've also worked with Mark on the HVAC and he's just as professional."
— Jim B., Google review"Excellent service and professionalism. Arrived on time, cleaned up after and did a great follow up. Will definitely use this company again!"
— Deanna N., Google reviewProbably not. Heat pump supply air is 85 to 95 degrees, cooler than your hand, and the house warms gradually. If the house is not warming at all, or the outdoor unit is a solid block of ice, or the thermostat is calling for auxiliary heat constantly, then it needs a technician.
That is the defrost cycle melting frost off the outdoor coil on a cold damp morning. It lasts a few minutes, the indoor air feels cool during it, and then heating resumes. Ice that never clears is a different problem.
Emergency heat runs the electric strips alone and bypasses the heat pump. Use it only when the heat pump has failed and you are waiting for a repair. Left on all winter it can triple the power bill.
Almost always a dirty flame sensor; sometimes a failing ignitor or a pressure switch. It is one of the quickest repairs we do and part of every fall tune-up.
Leave the house without touching any switch, then call the gas company and 911 from outside. Do not call us first; we will come once it is safe.
Flame sensors, ignitors, thermostats and defrost boards are at the low end; compressors and heat exchangers at the high end. The diagnosis comes first and the repair price is written down before the work, with the replacement number beside it when the system's age makes that the honest conversation. On a weekday, a technician's visit is a flat $175 diagnostic fee that covers the first hour at your home or business; parts and anything beyond that are priced in writing before we do them. Nights, weekends and holidays, the emergency fee is $360 and covers the first two hours of work; if the job will take longer, the technician gives you the price before going further. You hear the fee on the phone before anyone heads your way.
Something we didn't cover? See our full FAQ page or call (251) 680-7500.
Emergency heat, staging and the wiring mistakes that cost you all winter.
ThermostatsLicensed technicians for heat pumps and gas furnaces, same-day on most weekdays, the price in writing before the work.
Call (251) 680-7500 Request a Quote